AFi USB 2.0 Series Guida Utente

Series USB 2.0 Fiber Optic Extender User Guide 02/20/12JPK

10 PROBLEM CAUSE SOLUTION Link LED on MRX/RRX/MTX units are on, Host LED on MRX/RRX/MTX units are off. The host computer is not powered on. The M

11 PROBLEM CAUSE SOLUTION USB device is attached to MTX USB port, but MTX device LED is off. A USB device must have the appropriate driver installe

12 Specifications Range 10km over SMF, 1km over MMF USB device support High-speed devices (480 Mb/s) (USB 2.0) Full speed devices (12 Mb/s) (USB 2

13 LIFETIME WARRANTY INFORMATION American Fibertek, Inc warrants that at the time of delivery the products delivered will be free of defects in mater

14 Technical Glossary USB Cables USB cables have two distinct connectors. The Type A connector is used to connect the cable from a USB device to the

Thank you for purchasing the American Fibertek USB 2.0 Fiber Optic Extender Please read this guide thoroughly. This document applies to Part

Contents Introduction...

4 Introduction The instructions in this guide assume a general knowledge of computer installation procedures, familiarity with cabling requirements,

5 The MRX/RRX Unit The MRX/RRX unit connects to the computer/host using a standard USB cable. Power for this unit is provided by the USB on the host

6 The MTX Unit The MTX unit provides USB Type A ports for standard USB devices. The MTX unit allows you to connect up to four USB devices directly. A

7 Installation Guide USB extension up to 10 km over singlemode / 1 km multimode fiber optic cable Fiber Optic Link Cabling The MRX/RRX and MTX uni

8 Connecting the MRX/RRX Unit to the MTX Unit The MRX/RRX and MTX units are interconnected by up to 10 kilometers (single mode), 1km (multimode) of

9 Connecting a USB Device 1. Install any software required to operate the USB device(s). Refer to the documentation for the USB device(s), as requir